Select Page

Phoenix 2000 EPO Composite R/C Glider ARF


1 in stock


This 2 metre wingspan ARF glider is to assemble and lasts a lifetime!
The wings and tail are made from tough EPO foam. However, the fuselage is made from a really strong blow molded nylon skin*, Usually reserved for baby toys, with plywood formers, making it almost indestructible.

The virtually indestructible fuselage is smooth and rigid yet still light enough for the glider to perform. Both the main wing and tail are screwed into place and the two wing halves have a carbon fiber rod for added strength.

The main wing requires 1 servo per aileron for strong control surface movement plus there is a pre-molded slot so you can add your own flaps later. To complete this model you will require 4 9g servos, a 30A speed controller, a brushless outrunner, your own transmitter and receiver (Tx/Rx) and a 1300~1800mAh Lipoly battery.

This really is a super strong glider. I had one a few years back and even after shortening the wingspan by 40cm (hit a barbed wire fence) it still flew really well all be it a tad faster !!!

Wingspan: 2 meters (78.74inch)
Length: 1160mm
Flying Weight: 980g

I bring these in as ARF kits only as the electrics that come with the RTF ones are rubbish. Spend a little more on an ARF and upgrade the gear and you will not regret it.

Required. (Just ask if you need a price for these parts)
4 x 9g Servos
Brushless Motor (I usually have NTM Prop Drive 28-36 1000KV / 270W in stock)
LiPoly 1300~1800mAh 3S



There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…