Description
BSI Insta Cure CA Glue. 1/2 oz BSI 106
This is a half ounce bottle of Bob Smith Industries INSTA-CURE+™ Gap Filling CA Glue. INSTA-CURE+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as lamination’s, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1″ separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared.
Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.
Works Best On:
- Balsa Wood
- Ceramics
Works Good On:
- Soft Wood
- Fiberglass
- Hard Plastics
- Water-Resistant
- CA Hinges
WE HAVE MANY OTHER GLUES, ACCELERATORS AND THREADLOCK IN STOCK.
JUST ASK
